30
Coins / hr
BOOK TRAINING
TRAINING REQUIRED
Training required for this device.
Very good enclosed printer with AMS (Automatic Material System) that can process a wide variety of materials, even in a mix. Multicolor printing is also possible. (4 colors)
Specifications
Print volume (WxDxH): 256 x 256 x 256 mm Supported filament: PLA, PETG, TPU, PVA, PET, ABS, ASA
Safety Notes
Clean the building board with isopropanol after removing the print.
Software & File Formats
Slicer: Bambu Studio (In the lab on the plotter PC) Slicer can also be installed on your own laptop and the printers can be connected via LAN mode. https://wiki.bambulab.com/en/knowledge-sharing/enable-lan-mode
Maintenance
If your own (not Bambulab) material is used, this must be recorded manually on the device page in the AMS.